Installation Guide
Installed at your door in minutes
The ALL-IN smart door reader fits inside a standard light-switch electrical box and runs an electromagnetic lock. If there’s a power source near the door, installation is just a matter of connecting a few wires.
Always mounts on the inside — the secure side — of the door.
Up and running in three steps
Designed to drop into the door hardware you already have — most installs take just a few minutes.
01
Find a power source
Locate DC, AC, or PoE power near the door. Most doors already have a source close by, so no new runs are needed.
02
Mount in a standard box
The reader and controller fit inside a standard light-switch electrical box — no custom cutouts or special enclosures.
03
Connect the wires
Wire the reader to your electromagnetic lock and power supply. Once connected, it’s ready to manage from the app.
Three ways to power it
Whatever you have at the door, the ALL-IN can run on it — and it powers both the reader and the lock.
Recommended
Power over Ethernet
A single cable carries power and data — the cleanest install.
Input
12W min / 65W recommended (1 Amp)
Output
12 VDC, 800 mA
AC Power
Wire directly into standard mains power at the door.
Input
100–240 VAC (0.55A, 50–60Hz)
Output
12 VDC, 800 mA
DC Power
Connect to an existing low-voltage DC supply.
Input
12–30 VDC (2A max)
Output
Equivalent to input
Built to fit your door
Compact dimensions and flexible wiring mean the ALL-IN works with the locks and readers you already run.
Dimensions
In-wall
Depth
1.3 in / 3.3 cm
Width
2.0 in / 5.1 cm
Height
2.9 in / 7.3 cm
Faceplate
Height
4.6 in / 11.7 cm
Width
2.8 in / 7.1 cm
Depth
0.2 in / 0.5 cm
Supported setups
Fail-safe locks
Fail-secure locks
Parallel install with existing systems
Compatible with supplementary legacy Wiegand-based readers, so you can phase out old hardware on your own schedule.
Need a hand with installation?
Most doors are wired in minutes — and our team is here if you have questions before, during, or after install.